The Best Way to Paste Background at the corners: Directions, gluing outer, inner corner, docking

Step-by-step instructions to gluing inner corners

After finishing, the main problem can be uneven walls and the resulting springs on the wallpaper. It’s also essential to take into account that as soon as the walls are twisted the joints of wallpaper canvases could invisibly.

After gluing the last one in the front of gidpola.ru the inner corner of the fabric must measure the remaining distance. It is measured from the border of the glued cloth to the adjoining wall, and the resulting figure is inserted 10-15 millimeters. If the partitions are very curved, then the further figure could be more.

Cut a strip equal to the resulting figure, taking into consideration the allowance. The surfaces are treated with adhesive. Depending on the type of coating it may be exactly the wall or both surfaces.

The strip is glued independently using the cut side to the wall. The background should go on the opposite airplane.

In case the glued background is sterile, then you have to make a few smaller cuts perpendicular to the springs.

Level or incline on the adjacent wall is a vertical line. The distance from the corner is equal to the width of the former cut strip, not such as developments.

The surfaces are smeared with adhesive, and then the coat is glued to the wall using the flat side into the line. The cut goes onto the adjacent wall.

How to glue the outer corner (outer corner)?

Protruding corner ought to be pasted by analogy using an interior, however there are little differences, which also have to be taken into consideration when working.

Measured the space remaining from the glued background to the adjacent wall. Insert 20-25 millimeters to the figure.

A section is cut away, taking into account the added 20-25 millimeters.

Prior to gluing, the surfaces are treated with adhesive.

The even edge has to be glued to the background already fixed onto the walls, your own cut “extends” into the adjacent plane. If necessary, small cuts are created in the place of visiting the other background, smoothed and pushed to the wallsocket.

Draw a vertical strip onto the adjacent wall in a distance of only glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is put on the wall using its flat side towards the line, moving over the border of the already glued strip.

The joints are smeared with adhesive and ironed with a roller. Following that, the upper layer is cut along the ruler and the 2 layers are combined together.